Crystal Oscillator
Diode
Inductors
Electronic Amplifiers
Speaker’s
Buzzer-Speakers
Arduino
Raspberry Pi
PCB Board
PCB Service
Ceramic Capacitors
Electrolytic Capacitors
Polyester Capacitors
SMD Capacitors
Carbon Film Resistors
Network Resistors
SMD Resistors (0805)
Switch
THYRISTOR
PIC or DSPIC
Lights
Sensors
Transformer
Adapter
Motor’s
Battery
Fuse
Relay
Variable Resistors / Potentiometer
Wire
Uncategorized
Description
- Onboard the TP4056 lithium charge management chip The charging D1 indicator lights, charging is completed D2 indicator
- Onboard Micro USB head can directly link computer USB port charging
- The charging board can also be powered by a pin (IN and IN-)
- Reserved the TEMP pin header, and can be used as a lithium battery temperature detection PCB board size: 3.73 (cm) x1.5 (cm)/1.46”X0.59”
- Input voltage: 4V-8V maximum output charging current: 1000mA P4056 1A Li-Ion Lithium Battery Charging Module – Micro B USB is a 3.7V lithium battery charger module has onboard Micro USB interface. With Micro-USB onboard connector, you can directly connect to computer USB port for battery charging. If USB is not available you can use an external source voltage at IN /IN- pads, great for DIY projects. It is small size and lightweight.TP4056 Other features include the current monitor, under-voltage lockout, automatic recharge, and two status pin to indicate charge termination and the presence of an input voltage.
Note:Â
- This breakout board does not have overcurrent protection.
- Connect Ampere meter in series with 5V input end.
- The charging current is best to be 0.37 times of the battery capacity,
- Charging wire can’t be too thin or too long while interfacing.
- Make sure the board has good contact with the battery.
- Chip at work about 60 degrees fever is normal.
- Input reverse connection has no effect on the chip. Rather the output (battery’s) reverse connection will burn out the chip.
Reviews
Clear filtersThere are no reviews yet.